Recubed RF18 Mold

 

 

 

Mold Type: This is a 5x6" manual mold.
Temperature: 200C at zone 1
Material: Black Glass Filled PP
Additional Plates: None
Cycle Time: 30 seconds
Expected Output: 40 parts per hour, 30 with beaks

Notes:

Please read JY350-ST power on/off procedure first here.

Please also read the Manual Mold Installation on a JY360-ST here.

Operation

This mold requires you to remove it after each injection and manually open the mold to remove the part.  This part is fairly easy to remove.  It should not stick too much. Once the part is removed, put it back to gather, and place the mold back on the mold alignment plate (back left).  Hit cycle again to start the next part.  There is a pause after injection to let the part cool off in the mold to prevent warping.  While waiting, clean the part just pulled out of the machine so there is no need for additional cleaning time.

Quality Checks

  1. Make sure the part is fully formed.
  2. Check that the part is flat and not warped.
  3. Remove any flashing or gate remains.

Machine Setup: See pictures below.

PRODUCTION RATE NOTES:

TBD

NOTES:

20260430 - Created page