IM Hinge Backplate MOLD

 

 

 

Mold Type: This is a 8"x8" semi-automatic mold.
Temperature: 200C at zone 1
Material: Black Glass Filled PP
Additional Plates: None
Cycle Time: 60 seconds
Expected Output: 120 parts per hour, 100 with beaks

Notes:

Please read JY350-ST power on/off procedure first here.

Please also read the Automatic Mold Installation on a JY360-ST here.

Operation

This is a semi-automatic mold which only requires you to remove it after each injection and restart the cycle.  This part is fairly easy to remove.  It should not stick too much. Once the part is removed, hit the two green buttons to start the next part.  There is a pause after injection to let the part cool off in the mold to prevent warping and the plastic oozing into the columns.  While waiting, clean the part just pulled out of the machine so there is no need for additional cleaning time.

Quality Checks

  1. Make sure the part is fully formed.
  2. Check that the part is flat and not warped.
  3. Remove any flashing or gate remains.

Machine Setup: See pictures below.

NOTES:

20260509 - Updated injector settings. Ryan spent some time getting the part to fill correctly. There are no partial cavities like before.
20260415 - Created page