This mold produces the Recubed Front Platform (RCFP), a single cavity 5x5" automatic mold. It is run on the JY350-ST using the 5x5 adapter hardware.

 

Mold Type: 5x5" automatic mold
Temperature: 200C at zone 1
Material: Black PP
Additional Plates: 1.5" ejection system mold base
Cycle Time: <30 seconds
Expected Output: TBD

Notes:

Please read JY350-ST power on/off procedure first here.

Please follow the 5x5 Automatic Mold Installation procedure to install this mold. This mold has alignment pins — use the 3D printed alignment extension tools when installing.

Operation

Once the mold is installed and up to temperature, the machine will automatically open and close the mold each cycle. Your job is to remove the part after the mold opens. After the part is removed you have to remove the two pins that form the through holes on the parts and reinstall them in the bottom mold. They are held in place with magnets. Don't wait to long to pull them apart. It gets harder to remove the pins as it cools.

• Keep the mold warm/hot. It is easier to get the part out of the mold hot.
• Try to make the part stick to the B side (bottom) so the inside of the part is exposed — it is easier to grab internal structure to pull it free.
• Use silicone quick release to help release the part if needed. If parts turn white, run them through a flame and it goes away.
• Once the part is removed and pins are reinserted, hit cycle again to start the next shot.

Quality Checks

1. Make sure the part is fully formed.
2. Check that the part is flat and not warped.
3. Remove any flashing or gate remains.
4. Verify the part matches the Recubed Front Platform product page: dorfmueller.us/products/recubed-front-platform-family

Machine Setup: See pictures below.

[PLACEHOLDER - add machine setup photos once available]

 

PRODUCTION RATE NOTES:
TBD

NOTES:
20260517 - Created page. Confirmed mold has alignment pins.