Unmount Top H15 V2 Mold

 

 

 

Mold Type: This is a 8x8x8x mold.
Temperature: 200C at zone 1
Material: Black Glass Filled PP
Additional Plates: None
Cycle Time: 60 seconds
Expected Output: 60 parts per hour, 55 with beaks

Notes:

Please read JY360-ST power on/off procedure first here.

Please also read the Automatic Mold Installation on a JY360-ST here.

Operation

This mold requires no intervention on each shot.  Just remove the part and hit cycle again to start the next part.  There is a large pause after injection to let the part cool off in the mold to prevent warping.  While waiting, clean the part just pulled out of the machine so there is no need for additional cleaning time.

The ejection system does not push the part completely out of the mold.  You may have to use your hands to free by pushing it up.  I have made a leveraging tool to help do this (see below).

Quality Checks

  1. Make sure the part is fully formed.
  2. Using a .125" drill installed in a holder make sure all of the 3 holes are free of any plastic oozing back into the cavity.
  3. On the top clean up screw holes where the screw head sits.
  4. Check that the part is flat and not warped.

Machine Setup: See pictures below. Last updated 3/9/2026





Leveraging tool

PRODUCTION RATE NOTES:

TBD

NOTES:

20260430 - Created page